![]() If I configure OpenSUSE to manual ifup mode, would that put me on the right track?Īny suggestions on how to further troubleshoot NetworkManager as to why it won't connect, even though I have the correct settings now in /etc/wpa_supplicant/wpa_supplicant.Rtl8812bu mac driver. Restarting the system now automatically starts NetworkManager, and I don't get a connection. However, I would now like to configure this to auto-connect each time I start or restart the system. So I feel like I've made a huge step forward tonight. Using wpa_gui, I was able to successfully configure and latch onto the network! I then saved the configuration to /etc/wpa_supplicant/wpa_nf where it currently resides. I followed the directions to start wpa_supplicant manually, and loaded up wpa_gui. Here, I was able to see that the /etc/wpa_supplicant/wpa_nf file was almost empty, and had no configuration info. So I went back to this resource:, specifically to the section on manually configuring and connecting the wireless device: I also saw the wpa_supplicant would constantly try to be in an connected/active mode, but would always relegate to inactive. not sure if this may be part of the issue.Īfter combing through the wpa_supplicant logs, I was puzzled to see that the system latched onto the network, and then quickly kick off (this was recorded only once, right after I installed the device the first time). When playing around with NetworkManager in a more "advanced" mode, it seems like it can only be configured for a/b/g/n networks, where I'm trying to latch onto an 802.11ac network. I would also get the following pop-up whenever I wanted to edit the wireless connection: (States that "No agents were available for this request"). I noticed that NetworkManager was not saving a lot of the information I would configure it with, such as network passwords. ![]() Only way I can seem to do it is through a manual method. I made some good progress on this today, and got the the adapter to connect successfully to the network and am able to access the web. Lo Interface doesn't support scanning.iwconfig: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |